PPM Safety Certification Information

This device complies with Industry Canada license-exempt RS9 standard(s). Operation is subject to the following two conditions:

  1. This device may not cause interference, and
  2. This device must accept any interference, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Contact Numeris for help.

Changes or modifications not expressly approved by Numeris could void the user's authority to operate the equipment.

This equipment meets the U.S. government's requirements for exposure to radio waves. The exposure standard for wireless devices employs a unit of measurement known as the specific absorption rate, or SAR. The SAR limit set by the FCC is 1.6 watts per kilogram (W/kg).Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands.

Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. This is because the device is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base-station antenna, the lower the power output.

The highest measured SAR value for this device when worn on the body as described in this user guide is 0.881 Wfkg. For more information about the compliance of this device with the FCC RF emission guidelines, visit www.fcc.gov/oet/ea/fccid and search for the Grantee Code: IGK and Product Code: DA113A.

For body worn operation, this device has been tested and meets the FCC RF exposure guidelines when used with the belt-clip accessory provided by Numeris. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.

This equipment conforms to all electrical safety standards established by regulatory agencies in Canada and the U.S.A. It has been certified by Underwriter Laboratories, a Nationally Recognized Testing Laboratory, fully accepted by the Standards Council of Canada as a certification body. The UL-c mark is recognized by the Standards Council of Canada and provincial authorities throughout Canada.

 ‭(Hidden)‬ Catalog-Item Reuse